PENTENS E-500FLEX Solvent-free, Flexible Low Voiscosity Epoxy Resin

PENTENS E-500FLEX 100% solids, solvent-free, chemical resistant, elastomeric epoxy resin which combines the toughness, adhesion, and durability of epoxies with the flexibility.

ADVANTAGES

• Very good adhesion
• High chemical resistance
• Highly filled with mineral aggregates
• Tough, abrasion resistant
• Flexibility

USES 

• Trafficable sealant
• Flexible coating
• A crack bridging and waterproofing membrane

PHYSICAL DATA

APPLICATION 

Surface Preparation
The substrate must be clean and free from all lose particles, dust, cement laitance, oil and other contaminants.

Mixing
PENTENS E-500FLEX consists of a base and a hardener component. They are carefully mixed by means of a slowly rotating electric drill with paddle. Mineral aggregates are mixed with the binding resin by means of a forced action mixer.
The correct mixing ratio and for ecological reasons. Packs should be emptied thoroughly. 

Application
Application of PENTENS E-500FLEX is normally by means of rubber squeegees, roller or brush.
Allow to dry 12 hours or until tack free at 23°C surface temperature. Material cures slower at lower temperatures.

SAFETY

Impervious gloves and barrier cream should be used when handling these products.
Eye protection should be worn. In case of contact with eyes, wash thoroughly with plenty of water and seek medical advice if symptoms persist.
If contact with skin occurs, it must be removed before curing takes place.
Wash off with an industrial skin clearer followed by plenty of soap and water. Do not use solvent.
Ensure adequate ventilation when using these products.