PENTENS E-500 Solvent-free, Low Viscosity Epoxy Resin

PENTENS E-500 is solvent-free two part low viscosity epoxy resin with long pot-life, excellent mechanical properties such as Compressive, Flexural and Bonding strength, is a multi-functional structural epoxy grout.


ADVANTAGES

  • Good adhesion
  • High chemical resistance
  • Low viscosity
  • Good penetration
  • High mechanical
  • Environmental friendly

USES

  • Primer on mineral based substrates
  • For Concrete/Epoxy/Metal/Steel substrate
  • Epoxy mortar screed systems for Floor
  • Pavement
  • Epoxy mortar grouting systems for Structure
  • Repair
  • Low Pressure Epoxy Injection System
  • Composite FRP system
  • Art mortar system with colored aggregate

PHYSICAL DATA

APPLICATION

Surface Preparation
The substrate must be clean and free from all lose particles, dust, cement laitance, oil and other contaminants.

Mixing 

PENTENS E-500 consists of a base and a hardener component. They are carefully mixed by means of a slowly rotating electric drill with paddle. Mineral aggregates are mixed with the binding resin by means of a forced action mixer. 
The correct mixing ratio and for ecological reasons. Packs should be emptied thoroughly.

Application
Application of PENTENS E-500 as a primer is normally by means of rubber squeegees or rolling. The fresh primer cannot be over coated
within the next 24 hours.

Self-leveling screeds made from PENTENS E-500/AG-9(1:3) mixtures are applied by means of steel trowels floats or rubber squeegees on top of the primed surface. To obtain higher anti-skid scratch coats or self-leveling screeds they have to be strewn immediately with oven-dried quartz sand.

SAFETY

Impervious gloves and barrier cream should be used when handling these products. 
Eye protection should be worn. In case of contact with eyes, wash thoroughly with plenty of water and seek medical advice if symptoms persist.
If contact with skin occurs, it must be removed before curing takes place.
Wash off with an industrial skin clearer followed by plenty of soap and water. Do not use solvent.
Ensure adequate ventilation when using these products.​