PENTENS ECO-600TR Epoxy Clear Coat

────── Taiwan Green Material Label Product.       

PENTENS ECO-600TR is a special formulated two-component solvent-less epoxy transparent coating which is good abrasion resistant, chemical resistant, high polish gloss floor protective coat.


ADVANTAGES

  • Polish gloss
  • Seamless and easy to clean
  • Self-leveling
  • High mechanical loading capacity
  • Extremely high chemical resistance against a  range of aggressive chemicals, oil, various solvents, etc

USES

  • Marble-like design/Decorative floor
  • Polished Porcelain tile design floor
  • Food/Hygienic Industrials
  • Electric/Clean room design
  • Car park/Traffic Zones design
  • Assembling plants/Storage and logistic areas
  • Chemical and pharmaceutical industries
  • Institutional area

PHYSICAL DATA

APPLICATION

Mixing
PENTENS ECO-600TR consists of exact quantities of base and hardener components contained within the same pack. Before application, the base and the hardener
components are carefully mixed together by means of a slowly rotating electric drill with paddle. To complete mixing the resin is poured
from one can to another and mixed again. To ensure the correct mixing ratio and for ecological reasons packs should be emptied thoroughly.

Application
Application of PENTENS EC0-600TR is normally by means of steel floats or rubber squeegees. 
Freshly applied coatings have to be rolled with a spiked roller over the entire surface to remove entrapped air bubbles. To obtain higher anti-skid finishes the fresh PENTENS ECO-600TR coating should immediately be strewn with Silica sand in excess.

Curing
Room Temp: 25°C~35°C: 24 hrs
Room Temp: 10°C~25°C: 48 hrs
Full mechanical and chemical resistant is achieved after 7 days for full cured.

SAFETY

Impervious gloves and barrier cream should be used when handling these products.
Eye protection should be worn. In case of contact with eyes, wash thoroughly with plenty of water and seek medical advice if symptoms persist.
If contact with skin occurs, it must be removed before curing takes place.
Wash off with an industrial skin clearer followed by plenty of soap and water. Do not use solvent.
Ensure adequate ventilation when using these products.