PENTENS T-1168 Water-based Polymer Cement Floor Topping

PENTENS T-1168 water-based polymer cement floor topping is suitable for priming, leveling and repairing standard to highly absorbent concrete.

ADVANTAGES

• Ultimate wear resistance and anti-impact
• Hydrolysis system and good safety
• Ultimate adhesive strength
• High slump, good flow ability

USES

• Pavement material and primer
• Water resistant material
• Corrosion preventive lining material
• Covering material for deck of vessel

PHYSICAL DATA

APPLICATION

Surface Preparation
All the surfaces must be clean, free from grease, oil, laitance, and remove all the dirt and contaminants, which might affect adhesion.

Priming
Dilute 1 portion of PENTENS T-007 permeable primer with 3 portions of clean water and then apply directly to the surface, in order to improved the bonding.
Primer: 0.20 kg/m²/per coat

Application
In area of pit or concave place or depth exceeds 2 cm, shall be first filled by diluted PENTENS T-007 stirring with cement mortar.
After mixing of A-Comp with B-Comp. as per a fixed proportion, use trowel to plaster evenly and flatly on the primer.

Material consumption 

Approximately 6 kg/m² ready mixed mortar to achieve 3 mm layer thickness, and 10 kg/m² ready mixed mortar to achieve 5 mm layer thickness.

SAFETY

Impervious gloves and barrier cream should be used when handling these products.
Eye protection should be worn. In case of contact with eyes, wash thoroughly with plenty of water and seek medical advice if symptoms persist.
If contact with skin occurs, it must be removed before curing takes place.
Wash off with an industrial skin clearer followed by plenty of soap and water. Do not use solvent.
Ensure adequate ventilation when using these products.​